Tel: 0086.574.88461212 /84481166
Contact person:
Export Dept:0086.574.87056170
Home - Products - Hose Assembly - Hose Assembly - Correct assembly installation
Model: Correct assembly installation


Correct Assembly Installation

Since hose may change in length from +2% to -4% Under the surge of high
pressure,provide sufficient Slack for expansion and contraction

Hose should not be twisted.Hose is weakededwheninstalledinbwistedposition
Also Pressure in twisted hose tends to loosen fitting Connections
Design So that machine motion produces bending rather that bwisting

Never use a bending radius less than minimum shownin the hose
specilcationthe bending radius of hose should be far away from the
hose fitting (A>1.5R).

Leave proper Length when the hose is connected

Hose bending radius is bigger when it is in motion

Choise proper fittings,avoid too small bending
radius and excess force

Choice proper fittings,avoid twisting in hose lines
bent in two planes

Choice proper fittings,avoid excessive hose length

Avoid twisting in hose by using clamp properly

Reduce friction,avoid hose touching the object
directly or far Bway from the object